核心就是这一句ocnPrint(?output fout leafValue( getData(“/output” ?result “dc”)))

r_list = list(4000, 4100, 4200)
multi_list = list(20,21,22)
fout = outfile("/home/yourpath/results.txt" "w")
foreach(r_value r_list
    foreach(multi_value multi_list
        desVar(	  "r" r_value	)
        desVar(	  "multi" multi_value	)
        analysis('dc ?saveOppoint t  ?param "temp"  ?start "0"  
            ?stop "100"  ?step "10"  )
        run()
        save( 'v "/output" )
        fprintf(fout "multi %5.0f r_value %5.0f", multi_value*1.0, r_value*1.0)
        ocnPrint(?output fout leafValue( getData("/output" ?result "dc")))
    )
)
close(fout)

一个结果如下所示
multi 20 r_value 4000
temp © leafValue(getData()) (V)

0 439.268m
10 437.083m
20 434.987m
30 432.943m
40 430.945m
50 428.989m
60 427.07m
70 425.184m
80 423.325m
90 421.49m
100 419.672m

• ocean文档里的描述，如果直接使用"myfile"只有最后一次结果，定义fout = outfile(“/home/yourpath/results.txt” “w”)可以一直写入

If you provide a filename as the ?output argument, the ocnPrint command opens the file
and writes the information to it.

• ocean ref里面说getdata能和ocnprit配合使用，看一下电路看起来是封装symbol不能直接使用fprintf